Phones answered 24/7Longmont, Colorado
Call (833) 490-5225
Serving Boulder County

Hidden Water Leak Detection and Drying in Longmont

A technician traces leaks inside walls, under floors and beneath slabs, opens only what is needed, then dries the area the water reached.

  • Phones answered 24/7
  • St. Vrain flood history
  • Frozen and burst pipes
  • Old Town and West Side houses

Get a fast quote

Fastest: call (833) 490-5225. Or send this and we call you back.

Hidden Leaks

Hidden Leak Detection: what it covers

Quick answer

Hidden leak detection is the process of finding water escaping from a pipe, fitting or fixture where it cannot be seen, such as inside a wall, under a floor or beneath a slab. A technician uses meter readings, listening tools and moisture mapping to narrow the location, opens only what is needed, and dries the area the water reached. The pipe repair is a plumbing job.

Hidden Leak Detection illustration for Longmont, CO

A hidden leak does its damage out of sight. A supply line behind a wall can release water for a long time before a stain reaches the paint, and a fitting under a slab can soften the flooring above it without leaving any puddle. Often the first sign is a change in the water bill, a warm spot on the floor, or the sound of water moving when no fixture is running.

This service finds the leak and dries the area it reached. The technician works from what the home shows: the meter, the sound of the lines, the moisture in the wall and floor, and the route the plumbing takes through the structure. Opening a wall or floor is done only to the size needed to reach the leak, and each opening is checked for moisture before it is closed up again.

A crew is reached by calling (833) 490-5225, which is answered 24/7. Detection is not an emergency unless water is already coming through a ceiling or pooling on a floor, and in that case the call is handled as one. A crew is dispatched as fast as one is available, and no arrival time can be promised. Repairing the pipe is a separate plumbing job that the homeowner arranges.

Service area
Longmont & Boulder County
Availability
Phones answered 24/7
Warning signs

Signs you need hidden leak detection

Do not cut into a wall or floor without first checking for wiring, which often runs close to plumbing. If a leak location is known and safe to reach, turn off the water supply to that line, and do not attempt to repair a pressurized pipe yourself. Gas lines and water heater connections are not opened by a homeowner during a search. A technician carries the detection tools and checks for wiring before any opening is made, and plumbing repair is done by a plumber.

  • A water bill that climbs with no change in how the house is used
  • A warm or soft spot on a floor, or carpet that feels damp after a dry spell
  • The sound of running water or a hiss when every fixture is off
  • A musty odor with no visible source
  • Peeling paint, bubbling wall covering or a stain that returns after it is painted
  • Cracked grout, lifted tile or a gap where a tub or sink meets the wall
  • A water heater that runs more often than the household's use would explain
Our process

How our hidden leak detection visit works

  1. Interview and meter check

    The technician asks when the bill or the signs first changed and which rooms are affected. The water meter is read with every fixture off and again after a set interval, to confirm whether water is moving through the system with no use. The result decides where the search begins.

  2. Listening and pressure

    Listening devices are used on the lines to narrow a sound to a section of wall or floor. Where the system can hold pressure, a test shows whether the leak sits on the supply side or the drain side. A leak under a slab is usually traced by its sound and by the pattern of moisture above it.

  3. Moisture mapping

    A moisture meter and an infrared camera show where materials are cooler or wetter than the area around them. The technician marks the edge of the wet zone so that any opening is made in the right place and not on a guess.

  4. Targeted opening

    The wall or floor is opened only where the evidence points, and the exposed pipe is photographed. The homeowner is told before the opening is made and shown the leak once it is found. The repair itself is done by a plumber, and the crew does not perform it.

  5. Drying and closing

    Water that reached the framing, subfloor or flooring is removed and dried using the same measured approach as other water work. The opening is checked for moisture before it is sealed, and the homeowner receives the readings and photographs with the record.

Job stories

Typical jobs for hidden leak detection

Typical job
Illustration: Typical: a slow leak found behind a bathroom wall

Typical: a slow leak found behind a bathroom wall

What homeowners notice
The water bill rose over a few months with no visible wet spot. A soft patch appeared at the base of a bathroom wall and a musty smell came from behind the tub surround.
What we do
The crew reads moisture across the wall and the floor, finds the wet area behind the tub surround, and opens the smallest hole that shows the source. The wet framing and the subfloor are dried, and the opening is reported to the homeowner in writing.
What to expect
The homeowner knows where the leak was and has the readings that show it, so the repair can be scoped on the first call to a plumber.

one detection visit, then a drying visit typical visit

How can I tell if I have a hidden leak?

A rising bill, a damp floor or an odor with no source are the usual first signs, and a meter check can confirm that water is moving with nothing running.

The bill is the most useful clue because it changes slowly and can be compared with the same months in earlier years. A household that uses about the same water each month and sees a steady rise should look for a leak, even when no stain is visible. The meter test is simple: turn off every fixture and watch whether the meter still moves.

Other clues are physical. A floor that feels warm in one spot, carpet that stays damp after a dry spell, or a door that begins to stick as the frame moves can all point to water in or under the structure. None of these proves a leak on its own, so the technician checks them together with the meter.

Why can't most leaks be seen?

Pipes run inside walls, under floors and beneath slabs, and water follows the structure rather than the surface.

A supply line can be hidden behind drywall, inside a cabinet or under a tile floor. Water from a slow leak often travels along a wall stud or a floor joist and appears far from its source. The stain or soft spot is the end of the path the water took, not the start of it.

Soil, insulation and subfloor material absorb water and hold it, which is why a leak can look dry on the surface while the material below is still wet. A visual check is therefore not enough, and the crew uses tools that read moisture and sound.

How much of the wall or floor has to be opened?

Only enough to reach the leak and dry the area. The crew does not open more than the evidence supports.

Opening is the costly and disruptive part of this work. The technician uses the moisture map and the pipe route to decide where to cut, and the cut is made as small as the fitting allows. Each opening is photographed and checked for moisture before it is closed.

When the leak is under a slab or inside a wall finished in tile, the decision is more involved, and the homeowner is consulted first. The crew explains what the opening involves and what will need repair afterward, and no opening is made without the homeowner's agreement.

Should I wait for the leak to show itself?

No. Hidden water keeps moving into the structure, and waiting usually means more material to dry and more to replace.

A leak left running can soften a subfloor, lift flooring, swell the bottom of a cabinet and wet the insulation in a wall. Each of these adds material to remove and dry, and each becomes harder to reach once it has been finished over.

Early detection is less work because the water has reached fewer materials, so fewer finishes have to be opened and fewer pieces of framing have to be dried. A bill or a sound that has changed is a reason to call, even when the damage cannot yet be seen from the room. Waiting for a stain to appear usually means the water has already reached the next material down, and that is the point at which the job grows.

What makes this work take more or less time?

The price is explained and approved before work starts. The location of the leak and the amount of material it reached set most of the scope.

The location of the leak is the largest factor. A leak in an open wall or a basement is easier to reach than one under a slab, behind tile or inside a finished bathroom. The number of rooms reached and how long the water ran both change how much material must be dried.

Access, the age and finish of the walls and floors, and the number of openings needed also matter. A leak behind a finished bathroom wall needs a different plan from one in an unfinished basement, and the technician explains that difference in plain terms. Each factor is confirmed on site, and the homeowner is told the scope before any opening is made.

Options

Types and options for hidden leak detection

Wall leak

A supply line or fitting inside a wall often shows first as a stain on the far side of the wall or as a soft patch in the drywall. The technician works from the moisture pattern and the pipe route, then opens the smallest section that exposes the fitting. The area behind the drywall is dried before any patch is set.

Slab or under-floor leak

Pipes that run under a concrete slab or through a crawl space can leak for a long time before the floor shows damage. Warm or soft spots, a damp carpet edge or a change in floor height are common clues. The crew traces by sound and moisture, and drying covers the subfloor and the framing above it.

Fixture and drain leak

Leaks at a tub, a shower, a sink trap or a toilet seal often run down into the floor or ceiling below. The technician checks the cabinet, the surrounding wall and the room beneath before deciding where to open. Failed tile, grout and caulk are a common sign of this type.

Service line in the yard

An underground line from the meter to the house can leak in the yard, and the water may surface there or soak the soil against the foundation. The crew can help locate the wet zone that reaches the house, but digging up and repairing the line itself belong to a plumber and to the utility that owns it.

Boulder County

Why hidden leak detection is different in Colorado

Freezing is one reason a pipe can fail out of sight in this area. The National Weather Service's Boulder office listed frozen pipes and resulting water damage among the hazards of its January 2023 cold event. A pipe that splits in a cold snap may not leak until it thaws, and the water can then run inside a wall for some time before anyone notices it.

The Town of Firestone issued a notice that sustained temperatures below 20 degrees Fahrenheit can freeze pipes. Local news coverage in the Longmont area has given the same practical advice: let faucets drip, especially on exterior walls, insulate exposed pipes and seal openings that let cold air in. Those steps lower the chance of a hidden split, though none of them stops a leak that has already started.

Longmont sits in the Front Range valleys, where cold snaps reach hard. Local weather reporting described readings far below zero in January 2025 and a three-day cold spell in January 2026. A leak found after a cold snap is handled with the same approach as one found at any other time of year.

Need hidden leak detection today?

Call any hour and explain what is going on. You get a clear price before any work starts.

Related

Water Heater Leak Cleanup

A leaking tank soaks the floor and the wall at its base. Stop the water, remove what is wet, then dry the framing.

Appliance Leak Cleanup

A failed washer hose or dishwasher line spreads water under cabinets and into the subfloor. Stop it, then dry what is wet.

Ceiling Leak Water Damage

A ceiling leak soaks insulation and framing above the stain, so cleanup starts once the source is stopped and the wet material is removed.

Frozen Pipe Damage

A frozen pipe can split when it thaws, so the water damage often appears after the cold has already passed.

Guides

Read before you book

FAQ

Hidden Leak Detection FAQs

Is hidden leak detection an emergency?

Not usually. A leak still under a wall or floor is handled as a service call, and the crew works through it on a schedule that suits the homeowner. Water coming through a ceiling or standing on a floor is an emergency and is handled as one when it is reported. Phones are answered 24/7.

Will you repair the pipe?

No. The technician finds the leak and dries the area around it. Repair of the pipe or fitting is done by a plumber. Colorado plumbing contractor registration is handled by the State Plumbing Board within the Colorado Department of Regulatory Agencies (DORA), which is the regulator to ask about a plumber's standing.

Can you find a leak without opening walls?

Sometimes. Listening, pressure checks and moisture readings can narrow the area without any cut. When the evidence does not point to one spot, the technician explains the options before any wall or floor is opened.

Will my bill go down after the leak is fixed?

The bill is the best check on the fix, because it reflects the water that is used. The crew does not promise a specific reduction or a bill figure. The homeowner can compare the next billing periods with the earlier ones once the leak has been stopped.

Is drying part of the job?

Yes. Water that reached the framing, subfloor or flooring is removed and dried, and readings show when the drying is complete. Floors that were soaked may need to come up, and the crew says so when that is the case.

What if the leak is in the yard?

An underground line can leak where the water reaches the foundation. The crew helps find the wet zone that touches the house. Digging and repair of the line belong to a plumber and, for the service line, to the utility that owns it.

Does a hidden leak mean mold?

Damp framing and drywall are the materials where mold can start, so drying them is part of the work. Whether mold is present and what to do about it is a question for a specialist, not something the crew determines. The crew reports the moisture readings so that question can be answered.

WhatsApp