Does storm water need different cleaning from clean water?
Yes. Outside water carries silt, debris and whatever it touched on its way to the house, so it is handled as contaminated until it has been cleaned.
Clean water from a supply line has passed through pipes and is usually treated as clean at the start. Water from outside has crossed yards, streets and gutters, and may hold soil, fuel, animal waste and debris. Flood water can carry sewage and harmful germs, and Boulder County's recovery guidance says so plainly.
That is why the crew wears protective gear, bags the removed materials and cleans every hard surface that stayed. A homeowner who sees a clear puddle after a storm should still assume it is not clean. Anything that touched the water and cannot be cleaned to a dry, washable state is removed.
How does water get into a house during heavy rain?
Most entries are at ground level, where the grade, the openings and the foundation meet.
Grading is often the first factor. When the ground slopes toward the house, or a downspout drains onto a patio beside the foundation, water pools against the wall and seeks the nearest gap. Window wells, doorways and garage thresholds sit at the same level, so they are the usual points of entry.
Cracks in a foundation wall, gaps around pipes and cable penetrations, and sill joints that are worn or unsealed give water a route inside. Once it is through, water runs along the top of the footing and across the floor toward the lowest point, which is why the damage often shows as a line along a wall rather than in the middle of a room.
What should a homeowner do while the water is still rising?
Get people and pets to higher ground first, and leave the electrical panel alone if it sits in water.
Standing water and electricity are a shock hazard. Do not wade into water to reach a breaker panel or an appliance. If the panel sits in a flooded area, leave it alone and call the power utility for help before anyone goes near it.
Move valuables and documents up the stairs when it is safe to do so, and take photos of the water line and any damage before anything is moved. The crew and any insurance adjuster will want that record, and it is easier to make while the scene is still as the water left it.
Why does the lower level stay damp and smell for so long?
Silt and soaked insulation hold moisture and odor, and a basement is slow to dry without air movement and removal of the wet materials.
Silt is fine and holds water the way a sponge does. Once the standing water is out, a thin layer can stay damp beneath the surface, and cool basement air tends to slow evaporation. Odors often come from the material rather than the water itself, which is why removal matters more than fans alone.
The technician measures moisture in the slab edge, the bottom of the wall and the framing, not only on the floor. A basement that looks dry from the middle of the room can still hold water behind a wall or under a carpet pad. Drying is complete only when the readings are normal throughout the level.
What moves the cost of these jobs up or down?
The price is explained and approved before work starts. The factors below set how much work is needed, and each is confirmed on site.
The depth of the water and how far it spread are the largest factors. Water that stood on a concrete floor is different from water that reached the top of drywall in several rooms. The amount of silt, the number of materials that must come out, and whether a crawl space or wall cavities are affected also change the work.
Access to the lowest level, the age and finish of the walls, and whether the home has a finished basement all matter. A narrow stairway or a finished ceiling that must be opened adds labor, and the homeowner is told the scope before any removal begins.