What should I do first when an appliance is leaking?
Close the supply valve to the appliance, or the main water valve if there is no local valve, and unplug the appliance before stepping near it. Then move anything that water could ruin.
Most washers and dishwashers have a supply valve on the wall or under the sink, and turning it clockwise closes the flow to that appliance. A washer should be unplugged or its circuit switched off before the floor is touched, because the water and the electrical outlet are often close together. If the valve is stiff or does not stop the flow, the main shut-off is the next step, and a technician can confirm the flow has stopped.
Lift rugs, move furniture and pull small items out of the wet zone. Take photographs of the leak, the appliance and the floor before anything is cleaned, since those records help with any claim filed later. Do not run the appliance again to test it, because that can send more water through the same hose or line.
Can the hose or line be repaired, or does the appliance need replacing?
In most cases the failed part is a hose, a supply line or a fitting, and that part is replaced rather than the appliance. Replacing the appliance is a separate decision based on the unit's condition.
A washing machine hose is usually rubber or braided, and it fails at the crimp or at a thread. The fix is a new hose of the same length. Dishwasher supply lines and ice maker lines work the same way, with a compression fitting at each end. A technician checks the valve and the fitting before replacing the line, because a tight new line on a worn valve can leak at the connection.
The appliance itself can often keep running once the line is fixed, but water may have reached its base, its wiring or its drain connection. A technician looks at those points before the unit is returned to service, and the homeowner decides on repair or replacement with that information. The restoration crew works on the floor and cabinets whichever decision is made.
Why does a small appliance leak cause so much floor damage?
Water spreads under the appliance and into places no one sees. The first wet layer is rarely the only one.
A washer sits on a pan or directly on the floor, and water running from its base finds the lowest seam and follows it. Under a dishwasher, water runs beneath the toe kick and along the cabinet bottom, where it can wick up the inside of the panel. Flooring laid over the subfloor can hold water in the gap at its edges and beneath the planks or tiles.
Subfloor damage is the part people miss. Plywood and particleboard swell when they soak, and a swollen subfloor can push up the finish floor and crack tile grout. Once the subfloor softens, the crew has to decide whether it can dry in place or must be cut out, and a moisture reading settles that question better than appearance does.
What makes an appliance leak cleanup cost more or less?
The area that is wet, whether the subfloor is involved and how much cabinetry has to come out. No price figure is published here, and the price is explained and approved before any work starts.
The size of the wet zone is the first factor. A small puddle that stayed on a sealed floor is a short job. Water that reached the subfloor, ran under several cabinets or soaked into an adjoining room makes the job longer, because more material has to be opened and checked before it can be closed up again.
Access and flooring matter too. A laundry closet with little clearance is slower to work in than an open kitchen, and a floor of hardwood, tile or floating planks needs a different approach than sheet vinyl. The age and construction of the cabinets, and the number of cabinet units that must come out, change the steps. A technician sets out the scope on site before any work begins.
Is an appliance leak a flood job or a clean-water job?
Usually it is a clean-water loss, because the water comes from a supply line. If flood water has reached the appliance, the handling changes completely.
A supply-line leak starts with clean water, and drying is the main task. Boulder County's flood recovery guidance is the reason to treat water that came in from outside differently. It says flood water can carry sewage and harmful germs, so an appliance that sat in flood water is handled under the approach described on the sewage backup cleanup page rather than as a simple leak.
The deciding question is where the water came from. A washer that leaks from its own hose is clean-water work, while a laundry area that took water from outside is flood work. A technician asks that question on the first call, and the answer decides which steps the crew takes and which equipment it brings.