Phones answered 24/7Longmont, Colorado
Call (833) 490-5225
Guide

Checking for Mold After Water Damage in a Longmont Home

How to check a Longmont home for mold after water damage: where growth hides, the signs to look for, safe checks at home, and when to call a crew for removal.

Illustration for the guide "Checking for Mold After Water Damage in a Longmont Home" (Longmont, CO)
Short answer

Mold can start where wet material stays wet, often inside walls, under flooring and behind trim. Check for visible growth, a musty smell, staining and damp material before rebuilding. Boulder County's flood guidance names mold as a concern after flooding, so the check belongs in the cleanup plan.

Key takeaways

  • Boulder County's flood recovery guidance names mold as a concern after flooding.
  • Growth often hides inside wall cavities, under flooring and behind trim, where a visual check misses it.
  • A musty smell and staining can point to growth before any patch is visible on the surface.
  • Wet materials rebuilt over without drying can hold moisture that shows up later as growth.
  • Asbestos is a separate question from mold, and the Colorado Department of Public Health and Environment regulates asbestos abatement.
  • Whether growth is removed is a crew decision based on how much is found and where, not on a set rule of thumb.

Where does mold grow after water damage?

Mold grows where moisture stays long enough, usually in material that is porous or hidden from view. Drywall backing, insulation, carpet pad, the top of a subfloor and the framing behind a finished wall are the places that tend to hold it.

Mold needs moisture and organic material to grow, and the paper face of drywall, wood framing and carpet pad supply both. A surface that looks dry can still have a wet core, so growth may be well established where no one has looked. Growth inside a hidden cavity is the case most homeowners miss. A cavity behind a wet wall can stay damp for a long time after the surface looks finished.

Where the water traveled determines where to look. Water that ran down a wall or spread under a floor reached places far from the stain, so the check follows the water path rather than the visible line. Behind baseboards, inside closets, under cabinets and around window frames are spots that deserve a close look. Attics and the spaces above ceilings below a roof leak are also worth a look.

What signs point to mold before I can see it?

A musty smell, staining that returns after cleaning, peeling paint or a soft spot in drywall can point to growth inside a wall or floor. Each sign is a reason to check the area more closely.

Smell is often the first clue. A musty odor that is strongest near a wall, a floor register or a closet suggests moisture and growth in the material behind it. Staining that comes back after cleaning means the moisture source is still there, and peeling paint or a soft spot in drywall is worth opening up. A faint smell that grows stronger when the heat or humidity rises is worth noting.

Moisture readings help where the eye does not. A meter shows whether a wall, floor or framing is still wet compared with a dry reference area, and a crew uses readings to decide where to cut. A damp feel at the surface, even with no visible stain, can be reason enough to open a small section and look inside. Keep a record of readings and where they were taken, so you can see whether a wall is drying.

How do I check safely at home?

A homeowner can look and smell without disturbing the material. Avoid cutting, scraping or sweeping suspected growth, which can spread it through the room. A visual check is a first step, and it cannot confirm what is inside a closed material.

Start with a flashlight and a clear view of the room. Look at the baseboards, the corners, the back of furniture against exterior walls and the inside of any cabinet on a wet wall. Open windows and let fresh air move through the room before spending long periods inside it. Take the flashlight at a low angle along the wall, since light across the surface shows raised or stained areas.

Do not open a wall or pull up flooring to look unless a crew is present or you have confirmed that the material contains no asbestos. Older building materials can contain asbestos, and the Colorado Department of Public Health and Environment regulates asbestos abatement. A visual check is a good first step, but it does not show growth inside a closed material. Anyone unsure whether a patch is growth should leave it for the crew to examine.

What does mold removal involve?

Removal means taking out the affected material, cleaning the structure that remains, and drying it again. The scope grows with the area, so a small patch and a whole wall differ in both time and work.

A crew sets up containment before cutting, so dust and debris stay in the work area. Affected drywall, insulation and carpet pad are removed and bagged, and the framing underneath is cleaned, dried and checked again. The check after drying tells the crew whether the structure is ready to rebuild. Clean tools and bags are used for each area, and wet debris is sealed before it leaves the room.

The source has to be fixed first. If a leak is still running, or drying is incomplete, removing growth only to see it return wastes the work. A crew confirms the source is stopped and that readings are back in range before new material goes in. The steps for a small area and a large one are the same in principle, and only the size of the containment changes.

Who should take care during the check?

Anyone working inside a damp room should take basic precautions. Ventilate the room, wear gloves for any contact with wet material, and step out if a smell is strong or the work is making you uncomfortable.

A visual check needs little equipment, but close work around suspected growth is different. Gloves and a fitted mask are the minimum for anyone who handles wet material, and a room with a strong smell should be ventilated before anyone stays inside it for long. Keep the work area ventilated and the door closed to rooms that are not being cleaned.

Children, pets and anyone doing the work for the first time should stay out of the area during removal. A crew brings its own containment and protective equipment, which is a good reason to let a crew handle removal rather than doing it yourself in rooms the family uses. Plan the work for a time when the house can be left empty for a few hours.

What if the growth is behind a finished wall?

Growth behind a finished wall is found by opening a small test area, not by guessing from the surface. A crew cuts a limited opening, checks the cavity and decides how far the removal has to go.

The cut is kept small at first, so the condition can be seen without opening more than needed. Moisture readings inside the cavity show whether the framing is still wet, and a light or camera can show growth on the back of the drywall. The result decides whether the section is patched or replaced. Each opening is photographed and noted so the next visit can compare it with the first.

Once a section is open, the framing is cleaned and dried before anything is closed again. A rebuilt wall over a damp cavity can hold moisture for a long time, which is why the drying check comes before the new drywall goes up. The cavity is closed only after the readings are normal and the framing has been checked again.

What should I tell the crew when they arrive?

Tell the crew when the water first appeared, what the source was, which rooms were reached and what you have already noticed. Those details shape the removal list and the drying plan.

Describe the odors and staining you noticed and where they are strongest. Note whether the leak has been fixed and whether any repairs were made in the area before the water event. Earlier patch work can hide growth, so the crew will look behind it. A written list of rooms helps the crew plan containment and equipment before the first visit ends.

Photographs taken before any cleanup help the crew see the starting point. If something was already removed, say so and show where it was. A clear account saves time on the first visit and lets the crew give a more accurate scope. Mention any smell that came and went, since that pattern can help a crew find where to look.

When should I call a crew?

Call a crew when you find growth larger than a small surface spot, when a wall or floor smells of mold after drying, or when the water source has not been stopped. A crew can measure, remove and dry the area until readings return to normal.

Small surface growth on a hard, non-porous surface may be cleaned, but growth on drywall, insulation or framing is a job for removal. Growth that returns after cleaning, or that appears in a room that was already dried, points to a moisture source that still needs finding. A small patch that is treated and dried may be enough, while a damp wall usually needs more.

Call (833) 490-5225 to reach the nearest available crew, answered 24/7. A technician will come when one is free, and the crew will check the room, the cavity and the source before deciding on removal. Ask the crew to show the readings before they begin removal.

Frequently asked questions

Does Boulder County say mold is a concern after floods?

Yes. Boulder County's flood recovery health and safety guidance names mold as a concern after a flood, alongside the risk of sewage and harmful germs in floodwater. The county guidance is the right place to start for the local picture. The county guidance also covers sewage and harmful germs in floodwater, which is a separate concern from mold.

Can I just wipe the mold off the wall?

Wiping can spread growth and does not address moisture still inside the wall. Surface growth on a hard, sound surface may be cleaned, but drywall, insulation and framing with growth usually need removal and drying. Clean only the surface that is clearly sound.

Is a musty smell enough reason to act?

A musty smell is a reason to check, not proof of growth on its own. Look for staining, damp material and a source of moisture. A crew can take moisture readings and open a small test area when the smell is strong and the source is unclear. Note where the smell is strongest and when it appears, because that helps the crew choose where to open.

Who regulates asbestos found during a mold check?

The Colorado Department of Public Health and Environment regulates asbestos abatement. If a material may contain asbestos, stop before cutting or removing it and have it tested first, then follow the agency's guidance on the next step.

Does a dry room mean the mold is gone?

Not always. A surface can feel dry while the cavity behind it stays wet. The check that matters is the moisture reading inside the structure and a look at the back of any opened material, not only the feel of the surface. A reading that stays high after the surface dries points to moisture still inside the structure.

What should I do while I wait for a crew?

Stop the water source if it is safe to do so, keep the room ventilated, and keep people and pets out of the affected area. Take photographs, and avoid cutting or removing suspected growth yourself. Keep the room ventilated and keep a record of the photographs for the crew.

Sources

  1. Boulder County flood recovery health and safety guidance

This guide is general information for Boulder County homeowners, not a substitute for an on-site inspection. Prices are estimates. See our disclaimer.

Skip the guesswork. Call for a straight answer.

Tell us what's happening and we'll tell you honestly whether it's a quick fix, and what help should cost.

Keep reading

More guides

WhatsApp